Acoustics wiring replacement. Photoreport

For substituting of wiring by frontal acoustics with the level strengthening from a headunit, 8m of acoustic cable will be required.
I chosen DLS 2.5mm2

In left part, wiring will go under a steering column.
In right part under a whorehouse.
For the gasket of wiring the regular openings are utillized in a door, nothing on a metal, drilling is not necessary.

One after another, will begin with right part

For this purpose it is necessary to take off a whorehouse.
3 screw-bolts, 2 screws, are in overhead part of whorehouse, 2 screws on the right, under a lateral protective strap, where the passenger pillow of safety is disconnected.
A lateral protective strap is fastened on catches.
Take off.

We search rubber chokes in internal and external parts of kick-panels.
They are hardly below than plait of the regular wiring in a door.
Take off

We conduct wires from headunit, under a whorehouse, through openings in kick-panels.
That wires did not knock, bitoplast wrapped around and fastened gatherings.

In an external choke did opening, conducted a wire and put at a place.

For establishment of wiring in a door, I did opening in elastic of the regular wiring, hardly below than plait of send-offs.
We take off the card of doors, lead wires inside.
Place of entrance

For left part almost like. It is necessary to take off a plastic lid under a steering column.
Nothing difficult, a few screws and catches.
Here evidently, what in acquisition of LX wiring is shown out for the rheostat of change of brightness of illuminating from beneath.

It is necessary to take off a lower plastic lid in kiсk-panel.
You will untwist the screw-bolt of lever of opening of hood. There is a 1 percussion cap in a lid.

Entrance in a door like a right side.

For acoustics with crossover it is enough for the regular places of it.

For the level strengthening, I showed out wires for tweaters in lower part of lateral bars.

"Fidget", 2008

Ceed Club Russia